Hi
As you’ll all know the inside base cover of the Porsche Macan centre console cup holder has a mismatched insert - ie driver side is different to passenger side (see attached image).
This is great if you use different diameter cups or if you want a thin water bottle in one and fatter cup in the other.
But my partner and I use the same style vacuum mugs - which sit much better in the wider (non ridge) holder.
Anyone know of a way to swap the insert for one that is flat both sides?? It’s easy to take out completely but then you’re left with a raw finish and holes which you wouldn’t want to see without cups nor have liquid dripping down!
Thanks for any help!
Mismatched cup holder insert woes!!
http://www.porsche-code.com/PP37WLA6, a Dolomite Silver S, collected from Stockport OPC on Valentine's Day 2023, after a 399 day wait.
Ex.: Gen2 S, Volcano grey 1/9/19 - 3/2/23 & 39,235 Smiles, RIP
Ex.: Gen2 S, Volcano grey 1/9/19 - 3/2/23 & 39,235 Smiles, RIP
Only available in Crayon so far (this was at the PC this morning). You might be able to get one faster from Porsche than it takes me to print itNelladrahcir wrote: ↑Sat Sep 18, 2021 1:35 pm Could you 3d print me a 2022 Macan GTS please?
Any colour!!!
2017 Macan GTS Carmine Red
2005 Boxster S Artic Silver
2005 Boxster S Artic Silver
-
- Similar Topics
- Replies
- Views
- Last post
-
- 22 Replies
- 3393 Views
-
Last post by Cobnapint
-
- 5 Replies
- 1362 Views
-
Last post by Bluesnose1812
-
- 1 Replies
- 1041 Views
-
Last post by Scooby_Doo
-
- 0 Replies
- 3948 Views
-
Last post by PR-94