Replacement of Logos

Bigboyrolo · Post by **Bigboyrolo** » Thu May 21, 2020 10:21 am

I replaced the standard S with a red one (Porsche OEM).
The car colour affects how it looks, though it looked good on VG.
I put the standard S back on to sell the car.

Removing stuck on badges is so easy with a bit of heat applied, perhaps a domestic hair drier,
when warm they pull off easily.

davewf · Post by **davewf** » Thu May 21, 2020 10:52 am

If you use wd-40 make sure to use some panel wipe or meths afterwards to get rid of the wd-40 before sticking them down.

Adam_superman · Post by **Adam_superman** » Thu May 21, 2020 2:12 pm

Great advice everyone.

Thank you!!

Adam_superman · Post by **Adam_superman** » Thu May 21, 2020 3:50 pm

Gone for the stencil look

PaulR · Post by **PaulR** » Thu May 21, 2020 7:00 pm

I assume there's a 'NOT' logo in front of that one!!

Adam_superman · Post by **Adam_superman** » Thu May 21, 2020 8:21 pm

Haha, don’t worry it’s now gone

Adam_superman · Post by **Adam_superman** » Thu May 21, 2020 10:15 pm

Swapped them over just now. I’ve just left off the macan badge for now until I make my mind up which is best.

Thanks for the tips, I used the template and some thread. Worked a treat.

Paul · Post by **Paul** » Thu May 21, 2020 10:30 pm

Busy afternoon!

bobajob · Post by **bobajob** » Fri May 22, 2020 7:57 am

That's a big improvement. I'm tempted to do the same, my car is black and the rear badging is the only chrome / bright trim.

Paul · Post by **Paul** » Fri May 22, 2020 9:00 am

I don’t think I have any photos, but on my first SD I moved the Porsche lettering down an inch or so, almost in line with the bottom if the rear lights; just seemed to fill the space better having lost the Macan S lettering.......

Edit: not mine, this gives you the idea....

viewtopic.php?f=18&t=1380&p=25259&hilit=Badge#p25259

Replacement of Logos

Porsche Macan Owners Club

Follow Porsche Macan Forums